Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 6 · Fasten Molding with Nails

Position the adhesive-coated crown molding against the wall and ceiling. Using a pneumatic nail gun or a hammer, drive finishing nails through the molding into the wall studs and ceiling joists. Aim to place nails about 16-24 inches apart. Ensure nails are driven flush or slightly countersunk into the molding. If using a hammer, be careful not to dent the molding.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 6 · Fasten Molding with Nails

Position the adhesive-coated crown molding against the wall and ceiling. Using a pneumatic nail gun or a hammer, drive finishing nails through the molding into the wall studs and ceiling joists. Aim to place nails about 16-24 inches apart. Ensure nails are driven flush or slightly countersunk into the molding. If using a hammer, be careful not to dent the molding.

Videos for this step

Video 1Video 2Video 3

← Project

Crown Molding Installation

Step 6 of 9·1 min left

Measure and Mark
0 mins
Set Up Miter Saw for Angled Cuts
0 mins
Cut Crown Molding Pieces
0 mins
Dry Fit Molding Sections
0 mins
Apply Adhesive
0 mins
6
Fasten Molding with Nails
0 mins
7
Fill Nail Holes and Gaps
0 mins
8
Sand and Clean
0 mins
9
Paint or Finish Molding
0 mins
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.