Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 4 · Dry Fit Molding Sections

Before applying adhesive or fasteners, place each cut piece of crown molding into its final position along the wall and ceiling joint. Check the fit at the corners, ensuring the mitered joints meet snugly without large gaps. Look for any sections that might be too long, too short, or not fitting flush against the wall or ceiling.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 4 · Dry Fit Molding Sections

Before applying adhesive or fasteners, place each cut piece of crown molding into its final position along the wall and ceiling joint. Check the fit at the corners, ensuring the mitered joints meet snugly without large gaps. Look for any sections that might be too long, too short, or not fitting flush against the wall or ceiling.

Videos for this step

Video 1Video 2Video 3

← Project

Crown Molding Installation

Step 4 of 9·2 min left

Measure and Mark
0 mins
Set Up Miter Saw for Angled Cuts
0 mins
Cut Crown Molding Pieces
0 mins
4
Dry Fit Molding Sections
0 mins
5
Apply Adhesive
0 mins
6
Fasten Molding with Nails
0 mins
7
Fill Nail Holes and Gaps
0 mins
8
Sand and Clean
0 mins
9
Paint or Finish Molding
0 mins
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.