Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 2 · Set Up Miter Saw for Angled Cuts

For inside corners, you'll typically need a 45-degree miter cut on each piece of molding, angled towards the ceiling. For outside corners, the cuts are also typically 45 degrees, but angled away from the wall. Consult resources for the exact angles based on your specific molding profile and the exact angle of your corners if they deviate from 90 degrees. Adjust the miter saw's angle settings accordingly. Ensure the saw is stable and set up for safety.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 2 · Set Up Miter Saw for Angled Cuts

For inside corners, you'll typically need a 45-degree miter cut on each piece of molding, angled towards the ceiling. For outside corners, the cuts are also typically 45 degrees, but angled away from the wall. Consult resources for the exact angles based on your specific molding profile and the exact angle of your corners if they deviate from 90 degrees. Adjust the miter saw's angle settings accordingly. Ensure the saw is stable and set up for safety.

Videos for this step

Video 1Video 2Video 3

← Project

Crown Molding Installation

Step 2 of 9·3 min left

Measure and Mark
0 mins
2
Set Up Miter Saw for Angled Cuts
0 mins
3
Cut Crown Molding Pieces
0 mins
4
Dry Fit Molding Sections
0 mins
5
Apply Adhesive
0 mins
6
Fasten Molding with Nails
0 mins
7
Fill Nail Holes and Gaps
0 mins
8
Sand and Clean
0 mins
9
Paint or Finish Molding
0 mins
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.