Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings
Project video

Step 5 · Apply Adhesive

For each piece of crown molding, apply a continuous bead of high-quality construction adhesive along the back surfaces that will contact the wall and ceiling. Ensure the bead is consistent and not too thick, which could cause excessive squeeze-out. Work in manageable sections to avoid the adhesive skinning over before you can install the molding.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Apply Adhesive

For each piece of crown molding, apply a continuous bead of high-quality construction adhesive along the back surfaces that will contact the wall and ceiling. Ensure the bead is consistent and not too thick, which could cause excessive squeeze-out. Work in manageable sections to avoid the adhesive skinning over before you can install the molding.

← Project

Crown Molding Installation

Step 5 of 9·2 min left

Measure and Mark
0 mins
Set Up Miter Saw for Angled Cuts
0 mins
Cut Crown Molding Pieces
0 mins
Dry Fit Molding Sections
0 mins
5
Apply Adhesive
0 mins
6
Fasten Molding with Nails
0 mins
7
Fill Nail Holes and Gaps
0 mins
8
Sand and Clean
0 mins
9
Paint or Finish Molding
0 mins
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.