Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 1 · Measure and Mark

Using a tape measure, carefully record the length of each wall segment that will receive crown molding. For each piece, you will need to mark the molding at the appropriate lengths. Remember to factor in the corner angles, which will require angled cuts. A common approach is to measure the wall and add a small amount for the angled cuts, or to use a digital angle finder for precision.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 1 · Measure and Mark

Using a tape measure, carefully record the length of each wall segment that will receive crown molding. For each piece, you will need to mark the molding at the appropriate lengths. Remember to factor in the corner angles, which will require angled cuts. A common approach is to measure the wall and add a small amount for the angled cuts, or to use a digital angle finder for precision.

Videos for this step

Video 1Video 2

← Project

Crown Molding Installation

Step 1 of 9·3 min left

1
Measure and Mark
0 mins
2
Set Up Miter Saw for Angled Cuts
0 mins
3
Cut Crown Molding Pieces
0 mins
4
Dry Fit Molding Sections
0 mins
5
Apply Adhesive
0 mins
6
Fasten Molding with Nails
0 mins
7
Fill Nail Holes and Gaps
0 mins
8
Sand and Clean
0 mins
9
Paint or Finish Molding
0 mins
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.