Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 3 · Cut Crown Molding Pieces

Based on your measurements and the miter saw settings, carefully cut each piece of crown molding. For each corner, ensure you are making the correct opposing angle cuts. For straight runs between corners, you will likely need straight (90-degree) cuts, or beveled cuts if the molding meets another piece at an angle. Cut slightly long at first, then trim to fit precisely.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 3 · Cut Crown Molding Pieces

Based on your measurements and the miter saw settings, carefully cut each piece of crown molding. For each corner, ensure you are making the correct opposing angle cuts. For straight runs between corners, you will likely need straight (90-degree) cuts, or beveled cuts if the molding meets another piece at an angle. Cut slightly long at first, then trim to fit precisely.

Videos for this step

Video 1Video 2Video 3

← Project

Crown Molding Installation

Step 3 of 9·2 min left

Measure and Mark
0 mins
Set Up Miter Saw for Angled Cuts
0 mins
3
Cut Crown Molding Pieces
0 mins
4
Dry Fit Molding Sections
0 mins
5
Apply Adhesive
0 mins
6
Fasten Molding with Nails
0 mins
7
Fill Nail Holes and Gaps
0 mins
8
Sand and Clean
0 mins
9
Paint or Finish Molding
0 mins
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.