Skip to main content

Lay Out the Stringer Using a Framing Square — Mark the Stair Stringer with a Framing Square

Beginner4 hours

Part of project

How to Lay Out a Stair Stringer with a Framing Square · Step 4 of 6

Helpful?

In this video

Select a straight 2x12 piece of lumber for the stringer. Gather a framing square, a straight piece of wood (or square fence), and clamps. Attach the straight piece of wood to the framing square using clamps to set your unit run and unit rise measurements. For example, line up the 10-inch mark on the blade (unit run) with the edge of the wood, and the 7 and 5/16-inch mark on the tongue (unit rise) with the edge of the wood, then clamp. Perform a test mark on the stringer board to confirm accurate setup. If marks are incorrect, make adjustments to the square and clamps. Continue this process, sliding the square along the lumber to mark out each tread and riser. Stop marking once you've marked the last full tread.

3.6M views41.5K