Skip to main content

Test Fit the Straight Skirt Board — Dry Fit and Adjust

Beginner4 hours

Part of project

How to Scribe and Cut a Stair Skirt Board to Fit · Step 4 of 5

Helpful?

In this video

With the skirt board cut according to the measurements and angles, test fit it on the straight wall. It should align perfectly with the pencil line and have tight connections at the top and bottom. The presenter points out that a slight gap (e.g., 1/16th of an inch) above the marked line is acceptable as it allows for minor adjustments and will be covered by the riser. The goal is to ensure consistency along the entire length.

196.6K views5.1K
Transcript
Hide

be cut at 50 degrees so I've got the board cut now I haven't test fitted it yet so we're going to see how I did normally whenever I cut these this system the way I do it they turn out pretty much perfect every time so I can see down here I'm lined up and then up here I'll just bump that up a little bit so you guys can see that pencil line there we want it to be dropped in place and bottom and top the whole way up you can see that we're following the pencil line I've got a 16th of space right here I intentionally did that just to give me a little bit of margin for air but my Riser will end up covering all that so it's no big deal and then this like I said I wanted this to be three quarters of an inch high and I'm going to cut this off it might be flush with the subfloor it might be up a little bit depending on how I decide to do that shoe rail detail later now we're on our open side which is a lot more complicated cutting this skirt board out basically first we're going to start by doing the exact same process that we just did we're going to cut the skirt board to length and Notch it around get

Auto-generated transcript. May contain errors.