Skip to main content

Cut and Sand Skirt Board — Cut the Skirt Board

Beginner4 hours

Part of project

How to Scribe and Cut a Stair Skirt Board to Fit · Step 3 of 5

Helpful?

In this video

With all lines marked, it's time to cut the skirt board. First, match the pencil lines for the main angle with the miter saw. The presenter recommends angling the cut a few degrees (3-5 degrees) out of plumb (not a perfect 90-degree vertical cut) to create a better connection and allow for more space for adhesive. This slight angle ensures a tighter fit and a stronger bond. After making the initial angled cuts, use a jigsaw to cut out the smaller triangular pieces within the notched areas, following the marked lines. Finally, sand all edges smooth before installation to prepare them for finishing.

196.6K views5.1K
Transcript
Hide

make a mark for the next step we're going to be needing to make these lines Plum and level unfortunately the framing stringers are often not cut with the risers perfectly Plumb and a lot of times the Treads aren't perfect either so what I like to do is I make a lighter line first when I'm using my template and then I'll go back through with my level and I'll make a plum and level line with this guy as you see here now the thing I want to do is I want to find the point on on my previous line that's as far forward and as far up as possible and then I want to plumb down from that with a darker line so that I know which line I'm cutting to as you can see here my lighter line it was about an eighth inch out of Plum so I went from the furthest point forward and plumbed down it's important that you go to the furthest point forward because if you don't and then you go and put your Riser on you'll have a gap right here so we need to make sure that when we cut this we're staying just a little bit forward even of what our actual line is same thing whenever you do your Treads so I'm going to look at my two lines I'm going to see which one is higher than the other and I'm going to make a nice level line across there so as you see here I'm just a little bit higher than this line and then this line here I'm about a sixteenth a strong sixteenth higher with my actual line that's important that I get that higher when I make my level Mark that way whenever we make this cut and then put our finished tread down we get a nice tight connection right here so everything is all marked uh we're all Plumb and level so now I'm going to take this down to the miter saw and cut everything foreign so the first thing I do is match my pencil lines uh to the angle on the saw I know that I should be around about 39.8 or 40 degrees I'm putting the shadow line of my blade here on my pencil Mark and I'm right at a little under 40 degrees so that's great now the one thing that I do that's very important if you want to get a really crisp result is I don't cut these Square in the sense of vert a vertical cut I cut them a few degrees out of Plum and that makes my connections a lot better so here after I've got my miter angle I'm going to move my bevel angle over it can be anywhere from three to five degrees like so so now I'm cutting down into it this way if we go back over here to the staircase I'll show you why that's important we want our risers in our Treads to come together in a way that's…

Auto-generated transcript. May contain errors.