Step 4 · Mark the Stair Stringer with a Framing Square
Take your stair stringer board (typically a 2x10 or 2x12). Place your framing square on the edge of the board. Align the 'rise' measurement on the tongue of the square with the edge of the board, and align the 'run' measurement on the blade of the square with the edge of the board. Mark this line. This marks your first riser cut. Then, slide the square along the board, keeping the 'rise' measurement at the top edge and the 'run' measurement at the bottom edge, and mark the next riser. Continue this process, stepping the square down the board for each subsequent riser and tread, ensuring your measurements are precise and consistent. The bottom edge of the stringer will have the tread markings, and the top edge will align with the floor joists.