Skip to main content

Check Tread Level and Stringer Fit — Check for Plumb and Level of Treads and Risers

Beginner2 hours

Part of project

How to Measure Basement Stairs with Uneven Steps · Step 4 of 6

Helpful?

In this video

Place a spirit level on various treads to ensure they are perfectly horizontal. The presenter notes that some treads might be slightly high or low. Also, check the bottom of the stringer where it meets the floor. Mathematical calculations confirmed a 6.6mm discrepancy, indicating a small amount needs to be trimmed from the bottom stringer for a perfect fit. Use a spirit level to check the plumb of the newel posts, ensuring they are vertical.

9.1K views396
Transcript
Hide

see if we need to put this here. uh see uh if we need to trim any off the bottom of here. Obviously, as I said, I'll put my level on there to make sure that they're level. Check this uh once that's level across that tread as well. Check this for right. We can also double check the measurements cuz we know what the uh rise is so we can times it by how many however many treads are. But yeah, even if hopefully uh either that's got to be jacked up a little bit, it may be spot on, but worst case we can jack up a little bit or we can cut a bit off it. So, let's double check that. Right. So, put my level on it there. Let's have a look. So, we can see there. Interesting. Look, that shows it's very slightly low. If I try the next one, shows it's very slightly high. The next one slightly high. So I think slightly high. Look. So I think uh we're very slightly high. So I'll check the mathematical measurements here. But it looks like we we're on the right side here. We might just have to trim 5 mil off the bottom of that. So brilliant. Right. So just done a bit of mathematics. As I said, the rise is 196.8 and we got 12 treads down to this tread here. So uh that times by that is 2361. So, we should be looking for a measurement of 2361 from this tread up to the floor up here. So, let's have a look. As I said, I think we're a bit high. So, I'll pull my tape out. Here we go. What we got? Hold the camera as well. There. Yeah. So, as we thought, look what we got there. Can you see that? 2 3 55. So basically what we talking uh five or six mil we got to come down. So yeah spot on. Right. That's that bottom cut there. What I've done now is cut a little prop if you can hear me. Cut a little prop under this side here. Um put a level across. It's showing very slightly high there, but I'm not worried cuz there's slight diff a little bit of a discrepancy in this bottom step. More

Auto-generated transcript. May contain errors.