Skip to main content

Cut Stringers

Intermediate4 mins

Part of project

How to Lay Out Winder Stairs · Step 7 of 7

Helpful?

In this video

Using a 10 1/4-inch circular saw, carefully cut along all the marked lines. For gang-cutting, the saw blade will cut through the top two stringers completely and score the bottom stringer. After cutting the top two, remove them, then use the same screws to re-secure the now-cut top stringer to the scored bottom stringer. Cut the remaining stringer, connecting the scored lines. For the final cuts on the third stringer, use a jigsaw for precision where the circular saw cannot reach, particularly at the inside corners of the steps. Clean up any loose pieces as you go.

17.0K views813
Transcript
Hide

of the house. Pro tip for you. Cutting your stair stringers to minimize the effort and increase the accuracy. By laying them all three on top and cutting through my layout marks, I cut through two and I score the bottom one. Because I've screwed them together, I can pull the top one off. Screw through the same holes on the bottom two. Cut it again with that 10 and 1/4 in saw. And then all I have to do is connect the dots with the jigsaw. Now it's a lot easier on the first one than it is on the second. And really technically it gets harder on the second, a little bit harder on the third. This way they are all basically as identical as we're going to get them. It's also very efficient. So who said being fast is being sloppy? In order for this to work well, you have to take good care of your tools. That 10 and 1/4 in saw needs to be able to cut square. You know, imagine it just goes off to the side. will not run out again. The jigsaw, same thing. I like to use these screws. They're bas they're made for deck ledgers. By attaching the outside stringers to the walls, now they are just locked tight. Think of this as building a system. You can't use 2x8s for treads. Exacto. We are using them for riser. Since the stringers are already laid out, just match that layout to the very bottom riser. Pro tip, don't glue the stringer. Glue the riser. This is Advantex subfloor adhesive polyurethane foam to gel. It is stronger than your mother's love for you, but not stronger than my mother's love for me. Notice that those are PWT LVL's for the stair stringers. They are not going to crack, warp, or twist on me like 2x12 can. Translation: bomber stairs, especially once everything is glued and nailed with 3-in ring shank nails. Make sure that bottom stringer is on layout. To keep those stringers nice and straight, do the same thing in the middle on longer runs. The riser is 7 and 7/16. The 2x8 is 7 and 1/4. You know what that means? I don't have to rip the risers. There will be a small gap at the bottom, but that doesn't matter. Since I am correct-handed, I tend to work from right to left. Do the outside stringers first, flushing up the top, and then go ahead and nail the middle. Notice the 1x4 on the side of the stringer. Since we know for sure that this stair is not going to get a skirt, that 1x4 holds the stringers off so that the drywallers can just slip their drywall back without having to make any funky cuts. No, that is not grape jelly. That is the Advantex…

Auto-generated transcript. May contain errors.