Skip to main content

Mark First Step Cuts — Mark Stringers for Winder Treads

Intermediate4 mins

Part of project

How to Lay Out Winder Stairs · Step 6 of 7

Helpful?

In this video

Select your stringer material (a sturdy board). Using a speed square (or framing square) and the previously calculated individual rise (e.g., 7.7 inches) and run (e.g., 11 inches), mark the outline for the first step. Start with a vertical line representing the riser, then a horizontal line representing the tread. Ensure these lines are perfectly perpendicular and parallel using the square. The precision of these initial marks is critical for the accuracy of the entire stringer and serves as an initial layout verification.

8.6K views496
Transcript
Hide

run so do the math until you work it out so that it's close to seven for a rise 11 for a run I know I'm going to discard this piece so I'm going to cut a straight line 90° then 11 in I marked here 7.7 here I'll cut this and I'll make a jig if you want to be absolutely sure you don't waste any wood start halfway

Auto-generated transcript. May contain errors.