Skip to main content

Designing Winder Treads with Angles — Determine Winder Tread Layout

Intermediate4 mins

Part of project

How to Lay Out Winder Stairs · Step 5 of 7

Helpful?

In this video

Learn a geometric method for designing winder treads in a 90-degree corner. This method is often used for 3-step winders. You divide the 90-degree corner with lines at specific angles. The center tread is created by a line at 45 degrees. The other two treads are created by lines at 22.5 degrees from the starting and ending walls. This angular division helps to create a more balanced and potentially code-compliant distribution of the winder treads.

8.2K views114
Transcript
Hide

equal sized steps along the path instead of dealing with something like this. Next step let's go ahead and take a look at how winders are affected by concentric circles and how they might be interpreted by your local building department. So here we have a three step winder. One, two, three inside of a square however it could be a rectangle and instead of three steps you could always have two steps again using a walkline with the same measurement for each step. However this won't work if you start thinking outside the box and think that you can split these units of measurement up and draw your lines from the center and I actually stumbled across this pattern by drawing these lines here so thought I would share it with you and provide you with something that is going to produce measurements that are going to be different sizes along the walkline and since we have a 90 degree corner here the one in the center is going to be 45 degrees and the other two measurements this one and this one will be half of 45 or 22 and a half degrees for those of you trying to figure out a different way to design a four step winder that would have the same measurements along the walkline

Auto-generated transcript. May contain errors.