Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings
Project video

Step 5 · Label Wires

Using small adhesive labels or pieces of tape, clearly mark each wire with the letter of the terminal it was connected to (e.g., 'R', 'G', 'Y', 'W', 'C'). If your old thermostat had a jumper wire (often connecting R and Rc, or R and Rh), note this configuration as well, though many smart thermostats do not require jumpers.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Label Wires

Using small adhesive labels or pieces of tape, clearly mark each wire with the letter of the terminal it was connected to (e.g., 'R', 'G', 'Y', 'W', 'C'). If your old thermostat had a jumper wire (often connecting R and Rc, or R and Rh), note this configuration as well, though many smart thermostats do not require jumpers.

← Project

Smart Thermostat Installation

Step 5 of 12·1.4 hr left

Check Thermostat Compatibility
30 minutes
Turn Off Power to HVAC System
5 minutes
Remove the Old Thermostat Faceplate
2 minutes
Photograph Existing Wiring
3 minutes
5
Label Wires
5 minutes
6
Disconnect Wires and Remove Old Thermostat Base
5 minutes
7
Install New Thermostat Mounting Plate
10 minutes
8
Connect Wires to the New Thermostat
15 minutes
9
Attach the New Thermostat Faceplate
5 minutes
10
Restore Power to HVAC System
2 minutes
11
Configure Smart Thermostat Settings
30 minutes
12
Test Heating and Cooling Systems
10 minutes
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.