Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 6 · Assemble the Joint

Insert the flux-coated pipe end into the flux-coated fitting. Push it in fully until it seats firmly against the fitting's stop. Give the pipe a slight twist to ensure the flux is evenly distributed. Use a clean rag to wipe away any excess flux that squeezes out of the joint. Leaving excess flux on the outside can cause corrosion and an unsightly green patina over time.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 6 · Assemble the Joint

Insert the flux-coated pipe end into the flux-coated fitting. Push it in fully until it seats firmly against the fitting's stop. Give the pipe a slight twist to ensure the flux is evenly distributed. Use a clean rag to wipe away any excess flux that squeezes out of the joint. Leaving excess flux on the outside can cause corrosion and an unsightly green patina over time.

Videos for this step

Clean and Cool JointApply FluxFinal Cleanup and Inspection

Tools and Materials

← Project

How to Solder Copper Pipes for a Permanent, Watertight Joint

Step 6 of 9·14 min left

Preparation and Safety
15 mins5 itemsBeginner
Cut the Pipe
5 mins5 itemsIntermediate
Deburr and Ream the Pipe
2 mins1 itemsBeginner
Clean the Pipe and Fitting
5 mins2 itemsIntermediate
Apply Flux
2 mins4 itemsBeginner
6
Assemble the Joint
1 min4 itemsBeginner
7
Heat the Joint
2 mins6 items
8
Apply the Solder
1 min6 items
9
Cool and Clean the Joint
10 mins2 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.