Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 3 · Remove the Old Pump

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

With the plumbing disconnected, firmly grasp the old pump by its carrying handle. Do not lift it by the power cord or the float switch, as this can cause damage. Lift the pump straight up and out of the sump pit. It will be heavy and full of residual water and sludge. Immediately place the old pump into a large bucket or onto a prepared plastic sheet to prevent dripping dirty water onto your floor.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 3 · Remove the Old Pump

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

With the plumbing disconnected, firmly grasp the old pump by its carrying handle. Do not lift it by the power cord or the float switch, as this can cause damage. Lift the pump straight up and out of the sump pit. It will be heavy and full of residual water and sludge. Immediately place the old pump into a large bucket or onto a prepared plastic sheet to prevent dripping dirty water onto your floor.

Videos for this step

Test the SystemSet pump into sump pitInstall New Pump and Connect Piping

Tools and Materials

← Project

How to Replace a Submersible Sump Pump

Step 3 of 7·1.4 hr left

Disconnect Power and Prepare the Area
10 mins3 itemsBeginner
Disconnect the Discharge Pipe
15 mins4 itemsIntermediate
3
Remove the Old Pump
10 mins4 itemsIntermediate
4
Prepare New Pump and Clean Pit
20 mins6 itemsIntermediate
5
Install New Pump and Connect Piping
30 mins8 itemsAdvanced
6
Test the Pump Operation
15 mins2 itemsBeginner
7
Finalize and Secure
10 mins2 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.