Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 8 · Check for Leaks

Turn the shower water on and carefully observe both connection points: where the shower arm enters the wall and where the shower head attaches to the arm. Look for any drips, sprays, or seeping water. Let the water run for a minute to ensure the seal holds under pressure. If you see a leak at the shower head, try tightening it slightly. If you see a leak at the wall, you will likely need to shut off the water, unscrew the arm, and re-apply the thread seal tape before reinstalling.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 8 · Check for Leaks

Turn the shower water on and carefully observe both connection points: where the shower arm enters the wall and where the shower head attaches to the arm. Look for any drips, sprays, or seeping water. Let the water run for a minute to ensure the seal holds under pressure. If you see a leak at the shower head, try tightening it slightly. If you see a leak at the wall, you will likely need to shut off the water, unscrew the arm, and re-apply the thread seal tape before reinstalling.

Videos for this step

Reattach Shower Head and TestAttach Shower Head and Final TestIdentify the Source of the Leak

Tools and Materials

← Project

How to Replace a Shower Head and Shower Arm

Step 8 of 8·3 min left

Gather Tools and Materials
5 mins6 itemsBeginner
Remove the Old Shower Head
5 mins2 itemsBeginner
Remove the Old Shower Arm
5 minsIntermediate
Clean Threads and Flush Pipe
5 mins1 itemsBeginner
Apply Thread Seal Tape
5 mins2 itemsBeginner
Install the New Shower Arm
5 mins2 itemsIntermediate
Install the New Shower Head
2 mins3 itemsBeginner
8
Check for Leaks
3 mins2 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.