Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 7 · Install the New Shower Head

Ensure the small rubber washer is properly seated inside the threaded connector of the new shower head. Screw the new shower head onto the newly installed and taped shower arm. Turn it clockwise and hand-tighten it firmly. In most cases, hand-tightening is sufficient and recommended by manufacturers to avoid damaging the plastic threads or the washer. If the instructions specify using a tool, or if it leaks after hand-tightening, use your rag-wrapped wrench on the fitting's nut to give it a slight quarter-turn.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 7 · Install the New Shower Head

Ensure the small rubber washer is properly seated inside the threaded connector of the new shower head. Screw the new shower head onto the newly installed and taped shower arm. Turn it clockwise and hand-tighten it firmly. In most cases, hand-tightening is sufficient and recommended by manufacturers to avoid damaging the plastic threads or the washer. If the instructions specify using a tool, or if it leaks after hand-tightening, use your rag-wrapped wrench on the fitting's nut to give it a slight quarter-turn.

Videos for this step

Reinstall and Test ShowerheadInstall the New Showerhead HolderInstall the New Diverter

Tools and Materials

← Project

How to Replace a Shower Head and Shower Arm

Step 7 of 8·5 min left

Gather Tools and Materials
5 mins6 itemsBeginner
Remove the Old Shower Head
5 mins2 itemsBeginner
Remove the Old Shower Arm
5 minsIntermediate
Clean Threads and Flush Pipe
5 mins1 itemsBeginner
Apply Thread Seal Tape
5 mins2 itemsBeginner
Install the New Shower Arm
5 mins2 itemsIntermediate
7
Install the New Shower Head
2 mins3 itemsBeginner
8
Check for Leaks
3 mins2 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.