Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 7 · Install the New Angle Stop

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

Take the new angle stop and disassemble it. First, slide the new compression nut onto the copper pipe, making sure the threads face towards the end of the pipe. Next, slide the new compression ring (ferrule) on, with its tapered end pointing towards where the valve will be. Push the body of the new angle stop firmly onto the pipe until it stops. Slide the nut and ferrule up to the valve body and hand-tighten the nut. Now, use the two-wrench technique again: one wrench to hold the valve body steady (pointing in its final desired orientation) and the second wrench to tighten the compression nut. Tighten the nut about one-half to three-quarters of a turn past hand-tight. Do not over-tighten.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 7 · Install the New Angle Stop

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

Take the new angle stop and disassemble it. First, slide the new compression nut onto the copper pipe, making sure the threads face towards the end of the pipe. Next, slide the new compression ring (ferrule) on, with its tapered end pointing towards where the valve will be. Push the body of the new angle stop firmly onto the pipe until it stops. Slide the nut and ferrule up to the valve body and hand-tighten the nut. Now, use the two-wrench technique again: one wrench to hold the valve body steady (pointing in its final desired orientation) and the second wrench to tighten the compression nut. Tighten the nut about one-half to three-quarters of a turn past hand-tight. Do not over-tighten.

Videos for this step

Pre-set the New FerruleInstall New Nut and Compression RingConnect the Copper Tubing

Tools and Materials

← Project

How to Replace a Leaky Angle Stop (Shutoff Valve) Under Your Sink

Step 7 of 9·30 min left

Gather Tools and Prepare Work Area
10 mins5 itemsBeginner
Shut Off Main Water Supply
5 minsIntermediate
Drain the Line
5 mins2 itemsBeginner
Disconnect the Faucet Supply Line
5 mins3 itemsIntermediate
Remove the Old Angle Stop
15 mins3 items
Clean and Prepare the Pipe
5 mins2 itemsBeginner
7
Install the New Angle Stop
10 mins3 itemsAdvanced
8
Reconnect the Faucet Supply Line
5 mins2 itemsIntermediate
9
Turn Water On and Test for Leaks
15 mins2 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.