Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 6 · Clean and Prepare the Pipe

Once the old valve is off, thoroughly inspect the end of the copper pipe. Use a rag to wipe away any old plumber's putty, dope, or debris. Take a piece of emery cloth and gently sand the last inch of the pipe where the new compression ring and nut will sit. The goal is to create a clean, smooth, and slightly scuffed surface for the new components to seal against.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 6 · Clean and Prepare the Pipe

Once the old valve is off, thoroughly inspect the end of the copper pipe. Use a rag to wipe away any old plumber's putty, dope, or debris. Take a piece of emery cloth and gently sand the last inch of the pipe where the new compression ring and nut will sit. The goal is to create a clean, smooth, and slightly scuffed surface for the new components to seal against.

Videos for this step

Clean and Prepare PipeClean and Prepare ComponentsClean Pipe Nipple and Tile Surface

Tools and Materials

← Project

How to Replace a Leaky Angle Stop (Shutoff Valve) Under Your Sink

Step 6 of 9·35 min left

Gather Tools and Prepare Work Area
10 mins5 itemsBeginner
Shut Off Main Water Supply
5 minsIntermediate
Drain the Line
5 mins2 itemsBeginner
Disconnect the Faucet Supply Line
5 mins3 itemsIntermediate
Remove the Old Angle Stop
15 mins3 items
6
Clean and Prepare the Pipe
5 mins2 itemsBeginner
7
Install the New Angle Stop
10 mins3 itemsAdvanced
8
Reconnect the Faucet Supply Line
5 mins2 itemsIntermediate
9
Turn Water On and Test for Leaks
15 mins2 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.