Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 7 · Final Tightening and Leak Test

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Go back and check all the connections you made: the mounting nut under the sink and all the slip nuts on the P-trap and tailpiece. Hand-tighten them as much as you can, then use channel-lock pliers to give each nut a final quarter to half-turn. Be careful not to overtighten. Now, it's time to test for leaks. Close the sink stopper and fill the basin with a few inches of water. Let it sit for a minute to test the flange seal. Then, open the stopper and let all the water rush through the drain. As the water flows, carefully inspect every joint and connection with your hand and a flashlight for any drips. Check the P-trap nuts, the tailpiece connection, and where the trap arm enters the wall. If you find a leak, tighten the corresponding nut slightly. If it persists, you may need to disassemble the leaking joint and check that the washer is seated correctly.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 7 · Final Tightening and Leak Test

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Go back and check all the connections you made: the mounting nut under the sink and all the slip nuts on the P-trap and tailpiece. Hand-tighten them as much as you can, then use channel-lock pliers to give each nut a final quarter to half-turn. Be careful not to overtighten. Now, it's time to test for leaks. Close the sink stopper and fill the basin with a few inches of water. Let it sit for a minute to test the flange seal. Then, open the stopper and let all the water rush through the drain. As the water flows, carefully inspect every joint and connection with your hand and a flashlight for any drips. Check the P-trap nuts, the tailpiece connection, and where the trap arm enters the wall. If you find a leak, tighten the corresponding nut slightly. If it persists, you may need to disassemble the leaking joint and check that the washer is seated correctly.

Videos for this step

Inspect Washers and Reinstall P-TrapReinstall and Test for LeaksReassemble P-Trap

Tools and Materials

← Project

How to Install a Bathroom Sink Drain and P-Trap

Step 7 of 7·10 min left

Preparation and Removal of Old Drain
20 mins3 itemsAdvanced
Clean the Sink Drain Opening
10 mins6 itemsBeginner
Install the New Drain Flange with Putty
5 mins2 itemsIntermediate
Install the Drain Body and Tailpiece
15 mins8 itemsAdvanced
Assemble and Dry-Fit the P-Trap
20 mins3 itemsAdvanced
Connect the Pop-Up Stopper Mechanism
10 mins1 itemsIntermediate
7
Final Tightening and Leak Test
10 mins4 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.