Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 5 · Clean and Deburr Pipe Ends

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

The newly cut ends of the cast iron pipe will be rough and have burrs. For the coupling to seal properly, these ends must be cleaned and smoothed. Use a half-round metal file to smooth the sharp edges on both the inside and outside of the pipe ends. Afterward, take a wire brush and vigorously clean the outer surface of the pipe for at least two inches back from the cut. Remove all rust, scale, paint, and grime. The surface where the rubber gasket will sit must be perfectly clean and smooth.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Clean and Deburr Pipe Ends

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

The newly cut ends of the cast iron pipe will be rough and have burrs. For the coupling to seal properly, these ends must be cleaned and smoothed. Use a half-round metal file to smooth the sharp edges on both the inside and outside of the pipe ends. Afterward, take a wire brush and vigorously clean the outer surface of the pipe for at least two inches back from the cut. Remove all rust, scale, paint, and grime. The surface where the rubber gasket will sit must be perfectly clean and smooth.

Videos for this step

Cut and Deburr New PipeDeburr and Chamfer Cut EndsPrepare for Pipe Removal

Tools and Materials

← Project

How to Connect a PVC Drain to a Cast Iron Pipe

Step 5 of 9·55 min left

Safety and Preparation
15 mins6 itemsBeginner
Mark the Cut Lines
5 mins3 itemsBeginner
Support the Pipe
20 mins2 itemsAdvanced
Cut the Cast Iron Pipe
30 mins5 items
5
Clean and Deburr Pipe Ends
15 mins5 itemsIntermediate
6
Measure and Prepare PVC Pipe
10 mins4 itemsIntermediate
7
Install the Shielded Flexible Coupling
10 mins3 itemsIntermediate
8
Tighten the Coupling Bands to Spec
10 mins2 itemsAdvanced
9
Test the Connection for Leaks
10 mins2 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.