Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 6 · Tighten and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Once the slip nuts are hand-tight, use the channel-lock pliers to give each nut a final quarter- to half-turn. This will snug them up and compress the washer to create a watertight seal. Do not over-tighten. Remove the wet towels and place a clean, dry towel or paper towels under the reassembled trap. Turn on the faucet, first with cold water, then hot, and let it run for at least one minute. Closely inspect both slip nut connections for any signs of dripping or moisture. If a leak is present, try tightening the corresponding nut a little bit more. If it persists, you may need to disassemble and check the washer alignment.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 6 · Tighten and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Once the slip nuts are hand-tight, use the channel-lock pliers to give each nut a final quarter- to half-turn. This will snug them up and compress the washer to create a watertight seal. Do not over-tighten. Remove the wet towels and place a clean, dry towel or paper towels under the reassembled trap. Turn on the faucet, first with cold water, then hot, and let it run for at least one minute. Closely inspect both slip nut connections for any signs of dripping or moisture. If a leak is present, try tightening the corresponding nut a little bit more. If it persists, you may need to disassemble and check the washer alignment.

Videos for this step

Tighten FittingsTurn Water On and Check for LeaksTest for Leaks

Tools and Materials

← Project

How to Clean Out and Unclog a Bathroom Sink P-Trap

Step 6 of 6·5 min left

Prepare the Work Area
5 mins2 itemsBeginner
Loosen the Slip Nuts
5 minsIntermediate
Remove and Empty the P-Trap
5 mins2 itemsBeginner
Clean the P-Trap and Inspect Washers
10 mins4 itemsIntermediate
Reassemble the P-Trap
5 mins4 itemsIntermediate
6
Tighten and Test for Leaks
5 mins3 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.