Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 5 · Reassemble the P-Trap

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Slide the slip nuts back onto the tailpiece and drain arm, respectively. Position the clean P-trap back into place, aligning it with both pipes. Ensure the slip joint washers are correctly seated inside the nuts, with the tapered side of the washer facing the flared end of the pipe it is sealing against. Begin tightening the nuts by hand, turning them clockwise. Make sure they thread on easily; if you feel resistance, back them off and restart to avoid cross-threading.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Reassemble the P-Trap

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Slide the slip nuts back onto the tailpiece and drain arm, respectively. Position the clean P-trap back into place, aligning it with both pipes. Ensure the slip joint washers are correctly seated inside the nuts, with the tapered side of the washer facing the flared end of the pipe it is sealing against. Begin tightening the nuts by hand, turning them clockwise. Make sure they thread on easily; if you feel resistance, back them off and restart to avoid cross-threading.

Videos for this step

Reinstall the P-trapReconnect Drain PipesInstall the Trap Arm

Tools and Materials

← Project

How to Clean Out and Unclog a Bathroom Sink P-Trap

Step 5 of 6·10 min left

Prepare the Work Area
5 mins2 itemsBeginner
Loosen the Slip Nuts
5 minsIntermediate
Remove and Empty the P-Trap
5 mins2 itemsBeginner
Clean the P-Trap and Inspect Washers
10 mins4 itemsIntermediate
5
Reassemble the P-Trap
5 mins4 itemsIntermediate
6
Tighten and Test for Leaks
5 mins3 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.