Secure and Level Stairs with Stakes — Install Support Stakes
Part of project
How to Build Timber and Gravel Steps on a Slope · Step 5 of 8
In this video
To secure and level the stairs, drive stakes into the ground. Begin by setting two stakes at the top and bottom of the stair run. Use a level to ensure the stair box is horizontally level. Once satisfied with the leveling, screw the stakes into the side rails of the stair box. A rubber mallet is recommended for driving the stakes into the ground, as a hammer can damage the wood. Drive the stakes as far down as possible. For sections where 4-inch screws are too long and might protrude, use 3-inch screws for the stakes, or break off the protruding ends of the 4-inch screws with a hammer. Ideally, aim for at least one stake per stair bay, with two being optimal for maximum stability. If the soil is too rocky for wooden stakes, rebar can be used instead, hammered into pre-drilled holes (using a hammer drill if necessary) and then secured to the stair box with U-clamps. For sandy or loose soil, use stakes that are an additional one to two feet longer.
Secure and Level Stairs with Stakes — Install Support Stakes
Part of project
How to Build Timber and Gravel Steps on a Slope · Step 5 of 8
In this video
To secure and level the stairs, drive stakes into the ground. Begin by setting two stakes at the top and bottom of the stair run. Use a level to ensure the stair box is horizontally level. Once satisfied with the leveling, screw the stakes into the side rails of the stair box. A rubber mallet is recommended for driving the stakes into the ground, as a hammer can damage the wood. Drive the stakes as far down as possible. For sections where 4-inch screws are too long and might protrude, use 3-inch screws for the stakes, or break off the protruding ends of the 4-inch screws with a hammer. Ideally, aim for at least one stake per stair bay, with two being optimal for maximum stability. If the soil is too rocky for wooden stakes, rebar can be used instead, hammered into pre-drilled holes (using a hammer drill if necessary) and then secured to the stair box with U-clamps. For sandy or loose soil, use stakes that are an additional one to two feet longer.