Skip to main content

Build Bench Cubbies — Frame Interior Shelving or Cubbies

Beginner3 mins

Part of project

How to Build a Coat and Shoe Nook Under the Stairs · Step 5 of 9

Helpful?

In this video

Cut plywood strips to 12 inches wide for the sides, top, and bottom of the bench cubby unit. Cut two additional pieces for middle dividers. Assemble the main cubby box by screwing the side panels to the top and bottom panels. Then, install the two dividers, screwing them into place from the top and bottom panels. Ensure all joints are secure and square. Next, cut Arauco Moulding 1x3 trim boards to create a face frame for the cubby unit. Assemble this face frame using pocket holes and screws, then test fit it onto the cubby box. Apply wood glue to the front edges of the cubby box and secure the face frame using a nail gun and brad nails. Fill any nail holes and joints with wood filler, sanding smooth once dry.

189.7K views5.3K
Transcript
Hide

the framing on the door. And with that, I left the tall cabinets for now and moved onto building the cubbies that will go above the bench. I ripped plywood strips to 12 inches wide for this and cut two sides, a top, and a bottom, and two middle dividers to create a cabinet box about 6-foot long and 18 inches tall. Pocket holes and screws would work totally fine for assembly here as well, but no matter which side I put them on with the dividers and the bottom panel, they were going to show on one side or the other, and I didn't want to have to fill these holes. So instead, for this cabinet, I just assembled using screws through the side panels. I was going to need a way to secure this cabinet into the wall studs, so I did add two back supports, one at the top of the left section, and one at the top of the right section of this cabinet. And I screwed in the divider panels, making sure to keep everything square. Once this cabinet was assembled, I made a face frame from 1x3s to go onto the front. Just like the tall cabinet face frame, I assembled with pocket holes and screws, then test fit, and glued and nailed it onto the front. This part of the build was obviously, and thankfully, much quicker than the tall cabinet part. So at this point, all that's left to build is the bench, which is thankfully the easiest

Auto-generated transcript. May contain errors.