Skip to main content

Install Risers — Secure Your Risers

Beginner4 hours

Part of project

DIY Stair Risers · Step 5 of 6

Helpful?

In this video

Insert one end of the riser into the stair frame, ensuring the 5-degree bevel is on top. Rock the riser into place, sliding it into the routed grooves. The bevels should allow it to fit easily. Use a gauge block to position the front edge of the riser slightly higher (about 1/16 to 1/8 inch) than the planned tread height. This ensures space for adhesive and prevents the tread from sitting proud. Tap the riser with a rubber mallet if needed to achieve the desired position. Secure the riser by driving nails from the top of the riser into the stringer using a nail gun.

463.6K views10.3K