Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 6 · Reassemble and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Before reinstalling the trim, it's time to test for leaks. Go back to your main water shut-off valve and turn it on VERY SLOWLY. This allows the pipes to fill gradually. Go back to the shower and closely inspect the area around the newly installed cartridge stem for any drips or spraying water. If you see any leaks, shut the water off immediately and re-check your installation (e.g., is the bonnet nut tight enough? Is the clip fully inserted?). If everything is dry, you can proceed with reassembly. Slide the trim plate back over the valve and secure it with its screws. Re-install the handle, tightening the set screw with your Allen wrench. Turn the shower on and test its full range of motion, ensuring both hot and cold water are working correctly and are not reversed. Perform one final check for any leaks around the handle or behind the trim plate.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 6 · Reassemble and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Before reinstalling the trim, it's time to test for leaks. Go back to your main water shut-off valve and turn it on VERY SLOWLY. This allows the pipes to fill gradually. Go back to the shower and closely inspect the area around the newly installed cartridge stem for any drips or spraying water. If you see any leaks, shut the water off immediately and re-check your installation (e.g., is the bonnet nut tight enough? Is the clip fully inserted?). If everything is dry, you can proceed with reassembly. Slide the trim plate back over the valve and secure it with its screws. Re-install the handle, tightening the set screw with your Allen wrench. Turn the shower on and test its full range of motion, ensuring both hot and cold water are working correctly and are not reversed. Perform one final check for any leaks around the handle or behind the trim plate.

Videos for this step

Leak TestReinstall Cartridge and Test OperationPrepare and Test Shower Valve

Tools and Materials

← Project

How to Replace a Leaky Shower Cartridge (Delta Monitor & Moen Models)

Step 6 of 6·10 min left

Gather Tools and Supplies
5 mins7 itemsBeginner
Shut Off Water Supply and Relieve Pressure
10 mins1 itemsIntermediate
Remove Faucet Handle and Trim Plate
10 mins3 itemsIntermediate
Extract the Old Cartridge
15 mins3 itemsAdvanced
Clean Valve and Install New Cartridge
10 mins4 itemsIntermediate
6
Reassemble and Test for Leaks
10 mins5 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.