Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 5 · Clean Valve and Install New Cartridge

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

With the old cartridge removed, use a rag to wipe out the inside of the brass valve body. Remove any mineral deposits, sediment, or bits of old rubber gasket. A small nylon brush can help with stubborn deposits. Take your new replacement cartridge and apply a thin, even layer of plumber's grease to all of the rubber O-rings and seals. This lubrication is crucial for a smooth installation and a watertight seal. Carefully align the new cartridge with the valve body—most cartridges have markings like 'HC' (Hot/Cold) that must be facing up. Slide the new cartridge straight in until it is fully seated. For Moen, re-insert the retaining clip from the top until it clicks securely into place. For Delta, thread the bonnet nut back on by hand first to avoid cross-threading, then tighten it with channel-lock pliers until it is snug. Do not overtighten.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Clean Valve and Install New Cartridge

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

With the old cartridge removed, use a rag to wipe out the inside of the brass valve body. Remove any mineral deposits, sediment, or bits of old rubber gasket. A small nylon brush can help with stubborn deposits. Take your new replacement cartridge and apply a thin, even layer of plumber's grease to all of the rubber O-rings and seals. This lubrication is crucial for a smooth installation and a watertight seal. Carefully align the new cartridge with the valve body—most cartridges have markings like 'HC' (Hot/Cold) that must be facing up. Slide the new cartridge straight in until it is fully seated. For Moen, re-insert the retaining clip from the top until it clicks securely into place. For Delta, thread the bonnet nut back on by hand first to avoid cross-threading, then tighten it with channel-lock pliers until it is snug. Do not overtighten.

Videos for this step

Inspect and Clean the Valve BodyInstall New Cartridge and ReassembleClean and Flush Valve Body

Tools and Materials

← Project

How to Replace a Leaky Shower Cartridge (Delta Monitor & Moen Models)

Step 5 of 6·20 min left

Gather Tools and Supplies
5 mins7 itemsBeginner
Shut Off Water Supply and Relieve Pressure
10 mins1 itemsIntermediate
Remove Faucet Handle and Trim Plate
10 mins3 itemsIntermediate
Extract the Old Cartridge
15 mins3 itemsAdvanced
5
Clean Valve and Install New Cartridge
10 mins4 itemsIntermediate
6
Reassemble and Test for Leaks
10 mins5 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.