Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 8 · Solder the New Connection

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

Place the fire-resistant cloth behind the joint. Heat the fitting with the propane torch, focusing the flame on the thickest part of the fitting, not the pipe. After about 15-30 seconds, touch the tip of the lead-free solder to the joint on the side opposite the flame. The heat from the fitting should instantly melt the solder, which will be drawn into the joint by capillary action. Move the solder around the entire circumference of the joint until you see a continuous silver ring. Remove the heat and allow the joint to cool naturally for several minutes. Do not touch or disturb it while it cools.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 8 · Solder the New Connection

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

Place the fire-resistant cloth behind the joint. Heat the fitting with the propane torch, focusing the flame on the thickest part of the fitting, not the pipe. After about 15-30 seconds, touch the tip of the lead-free solder to the joint on the side opposite the flame. The heat from the fitting should instantly melt the solder, which will be drawn into the joint by capillary action. Move the solder around the entire circumference of the joint until you see a continuous silver ring. Remove the heat and allow the joint to cool naturally for several minutes. Do not touch or disturb it while it cools.

Videos for this step

Heat the JointSolder the ConnectionsSolder the Fitting

Tools and Materials

← Project

How to Replace a Frost-Free Outdoor Spigot (Sillcock)

Step 8 of 11·35 min left

Shut Off Water Supply and Drain System
10 mins1 itemsBeginner
Access the Interior Connection
15 mins3 itemsIntermediate
Measure and Purchase Replacement
5 mins2 itemsBeginner
Disconnect the Old Sillcock (Sweat Joint)
15 mins5 items
Remove Old Sillcock from Exterior
5 mins1 itemsBeginner
Prepare Copper Pipe and New Fitting
10 mins4 itemsIntermediate
Install New Sillcock and Apply Flux
10 mins3 itemsIntermediate
8
Solder the New Connection
15 mins6 items
9
Secure Sillcock to Exterior Wall
5 mins2 itemsBeginner
10
Seal the Exterior Penetration
5 mins2 itemsBeginner
11
Restore Water and Check for Leaks
10 mins1 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.