Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 11 · Restore Water and Check for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

First, ensure the new outdoor spigot is in the fully closed position. Go to the main water shut-off valve and open it SLOWLY, turning it counter-clockwise. Listen carefully for any sounds of rushing water, which could indicate a major leak. Once the valve is fully open, return to the basement/crawlspace and meticulously inspect the new solder joint for any signs of moisture. Wipe the joint with a dry paper towel to make it easy to spot even the smallest drip. If the joint is dry, the installation is complete. Go outside and test the new spigot's operation.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 11 · Restore Water and Check for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

First, ensure the new outdoor spigot is in the fully closed position. Go to the main water shut-off valve and open it SLOWLY, turning it counter-clockwise. Listen carefully for any sounds of rushing water, which could indicate a major leak. Once the valve is fully open, return to the basement/crawlspace and meticulously inspect the new solder joint for any signs of moisture. Wipe the joint with a dry paper towel to make it easy to spot even the smallest drip. If the joint is dry, the installation is complete. Go outside and test the new spigot's operation.

Videos for this step

Leak TestingTest for Leaks and FunctionalityRestore Water and Check for Leaks

Tools and Materials

← Project

How to Replace a Frost-Free Outdoor Spigot (Sillcock)

Step 11 of 11·10 min left

Shut Off Water Supply and Drain System
10 mins1 itemsBeginner
Access the Interior Connection
15 mins3 itemsIntermediate
Measure and Purchase Replacement
5 mins2 itemsBeginner
Disconnect the Old Sillcock (Sweat Joint)
15 mins5 items
Remove Old Sillcock from Exterior
5 mins1 itemsBeginner
Prepare Copper Pipe and New Fitting
10 mins4 itemsIntermediate
Install New Sillcock and Apply Flux
10 mins3 itemsIntermediate
Solder the New Connection
15 mins6 items
Secure Sillcock to Exterior Wall
5 mins2 itemsBeginner
Seal the Exterior Penetration
5 mins2 itemsBeginner
11
Restore Water and Check for Leaks
10 mins1 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.