Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 10 · Test the Repair

The final step before cleanup is to test your work. Go to an upstream fixture (like a sink or toilet) and run a significant amount of water down the drain. While the water is running, carefully inspect the new couplings and all connections for any signs of dripping or leaking. Place a dry rag or paper towel under the joints to make it easier to spot small drips. If a leak is found, you may need to tighten the coupling bands slightly more.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 10 · Test the Repair

The final step before cleanup is to test your work. Go to an upstream fixture (like a sink or toilet) and run a significant amount of water down the drain. While the water is running, carefully inspect the new couplings and all connections for any signs of dripping or leaking. Place a dry rag or paper towel under the joints to make it easier to spot small drips. If a leak is found, you may need to tighten the coupling bands slightly more.

Videos for this step

Test for LeaksTest for LeaksCheck for Leaks (Drain)

Tools and Materials

← Project

How to Replace a Cracked Cast Iron Drain Pipe with PVC

Step 10 of 11·35 min left

Preparation and Safety
20 mins4 itemsBeginner
Support the Existing Pipe
30 mins5 itemsIntermediate
Mark the Cut Lines
10 mins2 itemsBeginner
Cut the Cast Iron Pipe
60 mins6 items
Remove the Damaged Section
15 mins3 itemsAdvanced
Clean and Prepare Pipe Ends
20 mins6 itemsIntermediate
Measure and Cut the PVC Pipe
15 mins5 itemsIntermediate
Assemble the New PVC Section (If Needed)
15 mins4 itemsIntermediate
Install the Replacement Section
30 mins5 itemsAdvanced
10
Test the Repair
15 mins3 itemsBeginner
11
Clean Up
20 mins3 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.