Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 5 · Assemble and Solder New Valve

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

Before soldering, remove the plastic cartridges from the new valve body to prevent them from melting. Dry-fit the valve with short pieces of copper pipe and fittings (like couplings) to ensure everything lines up. Once satisfied, disassemble it. Using a brush, apply a thin, even coat of flux to the cleaned exterior of the pipe ends and the cleaned interior of the fittings. Reassemble the joints. Place your heat shield behind the work area to protect the wood studs. Using a propane torch, heat the fitting, not the pipe. When the flux sizzles and the copper changes color slightly, touch the lead-free solder to the edge of the joint. The heat from the fitting will melt the solder and capillary action will draw it into the joint, creating a complete seal. You will see a silver ring appear around the seam. Repeat for all connections.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Assemble and Solder New Valve

This is the step most people slow down on. Take it one move at a time — there’s no rush, and you can rewind the clip as many times as you need.

Before soldering, remove the plastic cartridges from the new valve body to prevent them from melting. Dry-fit the valve with short pieces of copper pipe and fittings (like couplings) to ensure everything lines up. Once satisfied, disassemble it. Using a brush, apply a thin, even coat of flux to the cleaned exterior of the pipe ends and the cleaned interior of the fittings. Reassemble the joints. Place your heat shield behind the work area to protect the wood studs. Using a propane torch, heat the fitting, not the pipe. When the flux sizzles and the copper changes color slightly, touch the lead-free solder to the edge of the joint. The heat from the fitting will melt the solder and capillary action will draw it into the joint, creating a complete seal. You will see a silver ring appear around the seam. Repeat for all connections.

Videos for this step

Solder New Valve AssemblySolder the New FittingSolder the Pipe and Fitting

Tools and Materials

← Project

How to Install a Two-Handle Shower Valve

Step 5 of 7·2.3 hr left

Preparation and Safety
30 mins3 itemsBeginner
Gain Access to the Valve
45 mins10 items
Remove Old Shower Valve
30 mins3 itemsAdvanced
Prepare Pipes for Installation
20 mins3 itemsIntermediate
5
Assemble and Solder New Valve
60 mins12 items
6
Secure Valve and Test for Leaks
30 mins6 itemsAdvanced
7
Install Trim and Handles
45 mins5 itemsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.