Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 5 · Perform Load Test

Connect a carbon pile load tester to the battery terminals. Follow the tester's instructions, which typically involve applying a load equal to half the battery's cold-cranking amperage (CCA) rating for 15 seconds. While the load is applied, monitor the voltage reading on the load tester or a connected multimeter. The voltage should not drop below 9.6 volts during the test. If it drops lower, the battery is likely failing under load.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Perform Load Test

Connect a carbon pile load tester to the battery terminals. Follow the tester's instructions, which typically involve applying a load equal to half the battery's cold-cranking amperage (CCA) rating for 15 seconds. While the load is applied, monitor the voltage reading on the load tester or a connected multimeter. The voltage should not drop below 9.6 volts during the test. If it drops lower, the battery is likely failing under load.

Videos for this step

Perform Battery Load TestPerform Load Test on a Good BatteryPerform Load Test on a Bad Battery

Tools and Materials

← Project

Car Battery Testing

Step 5 of 7·20 min left

Identify Battery Symptoms
5 minutes
Disconnect Battery Terminals
5 minutes2 items
Clean Battery Terminals
10 minutes2 items
Perform Voltage Test
5 minutes1 items
5
Perform Load Test
10 minutes2 items
6
Interpret Test Results
5 minutes
7
Reconnect Battery Terminals
5 minutes2 items
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.