Skip to main content

Connect Water Supply — Connect Water Lines

Intermediate2 mins

Part of project

Water Heater Installation · Step 7 of 13

Helpful?

In this video

Connect the cold water supply line and the hot water outlet line to the designated fittings on the water heater, ensuring the correct connections for cold and hot water. Use plumber's tape and pipe sealant as needed to ensure a secure connection.

38.5K views244

FAQs

Do I need specialized tools beyond basic plumbing gear for this project, and which ones are essential?

Yes, beyond basic wrenches and screwdrivers, you'll need large pipe wrenches (like the TradesPro 14 in. HD Pipe Wrench) for stubborn connections. A hand truck (like the Milwaukee 800 lbs. D-Handle Hand Truck) is crucial for safely moving heavy old and new units. For gas heaters, a gas leak detector or a soap solution for testing connections is also essential.

How much time should I realistically budget for a DIY water heater replacement, and is 'intermediate' difficulty accurate?

Budget at least a full day, and potentially two, as stated, especially if you encounter unexpected issues like corroded pipes or need to make trips for additional parts. The 'intermediate' difficulty is accurate because it combines plumbing, potential gas or electrical work, heavy lifting, and strict adherence to safety and code requirements, making it more complex than basic household repairs.

Transcript
Hide

threads now I'll install hand tighten only now we're ready to hook up our supply lines and our hot water line this tank comes with dialectric nipples with a non-metallic lining this helps prevent corrosion from dissimilar Metals so the first thing I'm going to install on the supply line is this leak Shield water shut off valve it's an automatic shut off valve that will stop the flow of any water to the hot water heater if it detects a leak down on the floor I'll start by pulling the release pin and removing the te set the electronic piece aside for all the threads on the fittings I'm going to apply plumbers tape and thread sealant now that that's done screw it on I'll get a pair of adjustable pliers and tighten it up get my tea ready and follow the same procedure so next we're going to install our thermal expansion tank this tank helps keep the water pressure consistent into the hot water heater it also helps eliminate water hammering which is the noise caused in the pipes as the air expands while the water is heated we're going to check the tank it's at about 45 PSI since our house tested at 60 we're going to want to add some air to increase pressure use a manual pump until the tank pressure matches the house pressure then thread the tank onto the te and then I'll finish the last half the 3/4 turn with the wrench now that that's set up I'm going to install this connection nipple from our T to be able to connect our flexible hose so now we're ready to install this pre-made water supply line it's got a rubber gasket on the inside of it so we won't need to Teflon tape or pipe dope this connection the top has a shark bite fitting and a shut off valve so we'll start threading that on I'll bend the flex hose up to check the PEX length if you need to cut the PEX use a Pex cutter for a clean cut for the shark bite fitting I'll prep the packs with a deuring tool spin it on the pipe 10 times the tool can also be used as a gauge to Mark the fitting depth now I'll push the shark bite onto the PCS to meet the mark I'll install the flex hose on the hot water side the same way as the cold side now that our water lines are hooked

Auto-generated transcript. May contain errors.