Skip to main content

Sand and Finish the Handrail — Sand and Finish Handrail

Beginner6 hours

Part of project

How to Install a Handrail on Basement Stairs · Step 6 of 6

Helpful?

In this video

After routing, any remaining flat spots from the routing process are eliminated through careful sanding. It's crucial to pay close attention to how the surface feels, as hands will continuously interact with the handrail, and any imperfections will be noticeable. Once the desired smoothness is achieved, a wipe-on polyurethane finish is applied. This finish is typically applied in three or four coats, with light sanding (e.g., with 600-grit sandpaper) between each coat to ensure a silky-smooth surface. The video then briefly shows the balusters fitting into the routed groove on the finished handrail, demonstrating the final assembly concept.

118.7K views4.6K
Transcript
Hide

That little flat is then eliminated with some sanding As you sand, pick careful attention to how the surface feels Hands will be run across this railing for many years any imperfection will stand out The same is true when you apply your finish This is a wipe on poly and it must be lightly sanded with say 600 grit Between each of the three or four coats to ensure a silky smooth surface Later when the balusters are installed the tops will go into that groove on the bottom of the railing And then the spaces between them will be filled with pieces of oak But that's a different video. See you next time

Auto-generated transcript. May contain errors.