Skip to main content

Temporarily Install Skirtboard and Verify Angle — Test Fit the Skirt Board

Beginner8 hours

Part of project

How to Install Stair Skirt Boards on an Existing Staircase · Step 3 of 7

Helpful?

In this video

Once the bottom line is marked on the wall, carefully position the skirtboard material (the 1x10 board) onto the wall, aligning its lower edge precisely with the marked line. Temporarily tack the skirtboard in place using nails or screws. This allows for verification of the angle before permanent installation. Using the digital level again, place it on the temporarily installed skirtboard to confirm that its angle perfectly matches the previously determined stair rake. This step is crucial for ensuring the skirtboard is installed at the correct pitch.

309.3K views4.6K
Transcript
Hide

go to town now that I have the bottom of my skirt marked and I have my angle all I have to do is get a rough measurement on the length make it a little extra long and then I can cut the skirt board and I'll tack it in place when you cut this thing your top cut is going to be whatever the measurement in your level was so if it was 38 degrees my plumb cut is 38 and then the compliment is gonna be the long cut on the bottom which in this case would then be 52 degrees first thing I'm gonna do is tack the bottom and then I'm gonna grab my digital level again and this is a really important part I'm gonna use that digital level and make sure that this skirt board is exactly on the angle that I want it to be I'm not even going with my pencil marks I'm actually gonna use the level itself to make sure it's perfect then I'm going to put another nail on the top for the next step I always keep a jig in my stair kit some would call this riches

Auto-generated transcript. May contain errors.