Skip to main content

Precisely Miter Cut Skirt Boards — Cut the Skirt Board

Beginner8 hours

Part of project

How to Install Stair Skirt Boards on an Existing Staircase · Step 2 of 7

Helpful?

In this video

Transport the marked PVC board to a miter saw. The video highlights the use of an 8.5-inch Makita miter saw, specifically noting its ability to miter up to 60 degrees in both directions. This feature is essential for efficiently cutting both left and right-side skirt boards from the backside without re-jigging. For the mitered cuts, intentionally "overcut" the angle by approximately an inch. Then, when making the square cut for the tread, retract the saw blade just enough to "clip out" the overcut portion, resulting in a clean, tight joint. Repeat this process for all mitered cuts along the traced lines.

24.8K views248