Skip to main content

Install Handrail and Final Fastening — Install the Handrail

Beginner8 hours

Part of project

How to Install a Handrail on Deck Stairs · Step 6 of 7

Helpful?

In this video

Align and lower the handrail onto the installed balusters. Start at one end and carefully work the handrail into place. Once aligned, fasten the handrail permanently to the newel posts using GRK screws, just like the initial newel post installation. Use a level to ensure the handrail is straight and level. Use wood plugs to conceal the screw holes for a finished appearance.

64.9K views1.3K
Transcript
Hide

that you pay attention to that. Just start at one end, drop the handrail into place, kind of work it in and uh it goes pretty quick on these flat runs. It's pretty easy because everything mortise wise and length of ballister wise should be exactly the same length. It's a little bit harder to do this on a rake. Um but you know, you get the picture here. I'm just putting my wood plugs in just to get this section of rail done. And then we can move on down to this rake section. For some reason, I didn't take video of this, but we want to do the layout on our treads the same way. I like to use the tan tape. Mark the centers with a pencil. And then I didn't show laser plumbing our marks up and marking the underside of the handrail, which is important, but I did that already. And I'm drilling all the holes. And then I'm going through and hand mortising uh the square mortises on our treads. Also takes a little bit of time, but that is just part of it. Whenever people want this square mortise look without ballister shoes, it's a premium price for a premium job. Takes more time to do this, but it's worth it in the end. It yields a really clean, crisp look once everything's all done. Now, we move on to removing our handrail so that we can mortise it. I've just got this tacked in place with some GRK screws. Again, I I drill a 1/2in hole with a forstenner bit and then use GRK screws to fasten the handrail. We're moving over to the mortiser. Getting it set at the angle to match the stair. I use a digital angle gauge to do this works extremely well because it magnetically holds onto the chisel. So, I'll match that up, bolt it down in the back, and then go to town. It is a little bit of a struggle mortising this white oak because it is so hard. You really have to push down hard on uh the handle a lot of times. And for some reason, this machine, the head can actually spin a little bit. So, you have to watch that it doesn't move over time. Having a good sharp chisel and drill bit really helps with this. So, take care of your stuff as much as possible. Um, you don't want to attempt this on a white oak handrail with a dull chisel and bit. I didn't take a video of me measuring the ballusters, but I essentially go and tack that handrail back into place. Then I measure all of my ballister lengths. If your stair is built properly, the front, middle, and rear ballister will be the same length on every tread. That doesn't always happen. in which case I'll usually take the smallest…

Auto-generated transcript. May contain errors.