Skip to main content

Measure, Cut, and Install Handrails — Prepare Handrail for Mounting

Beginner8 hours

Part of project

How to Install a Handrail on Deck Stairs · Step 5 of 7

Helpful?

In this video

With the treads and lower newel post installed, prepare and attach the handrails. First, determine the correct angle for the handrails by resting a section against the posts and marking the necessary cuts. Use a bevel gauge to transfer this angle to a power miter saw for precise cuts. An angled cut should also be made on the top of the newel post for a finished look and proper fit for the handrail. Once cut, position the handrail, clamp it into place, and secure it to the newel posts and any intermediate supports using weather-resistant stainless steel screws and the cordless drill. Ensure the handrail overhangs the top post by approximately 3/8 of an inch, measured with a combination square, for aesthetic and functional purposes.

2.5K views73
Transcript
Hide

Now, this is going to be one part of the hand rail, guys. So it's important right now to figure out what our basic angles are going to be. Suzanne, hold that right there for me right at the front edge of that post for you. I've measured up the same distance on this one, as from here to here. Can you got that? All right. So let me draw this angle right here. This bevel gauge will allow me to transfer the angle I just drew on the railing to the power miter box. Swing the bed until the edge of this cut groove right here. Lines right up with that bevel gauge. With the angle set, the cuts are made. Now, the angle should be in exact match. Perfect. Oh. Before we attach the railing, I make an angled cut on the top of the post, then we screw the top rail in place. Good. Okay, let's take the clamp off. Then I'm going to put the other two screws in, and I'll start cutting the top of the hand rail. Well, as the sun is going down, we're putting on the last few pieces. This is the top of the hand rail right here. Now, we want this to overhang about three eighths of an inch. I've set our combination square up for that. There we go. Okay. Suzanne, can you hold that right there? Just one second. We're going to put our hand railing in place. Suzanne attaches it to the top railing using those stainless steel screws. Very nice. Well, I was going to head down the road this morning, but you know, even for me, some of these projects just take longer than you think. So I'm going to head over and wake up Len and Suzanne in a moment. And we're going to finish up those steps right after I have some breakfast. Hey, Lenny. Suzanne, good morning. Morning. Morning. Morning. Morning. Ready to get to work? Sure. Come on down. Oh, thank you. Nothing. Very much. Good morning, guys. Good morning. Good day. This is it. All right. Let's just pick this up where we left off on the hand rails or that lower section of the hand rails. Okay. Before it got too dark, yesterday, we measured and cut the lower railing. So all we have to do this morning is attach it. There we go. Okay, then if you'd do the two down there at the bottom, sir, we'll do. And I'll grab the other rails. Well, look at what you two have done, huh?

Auto-generated transcript. May contain errors.