Skip to main content

Attach Cleat and Spacers to Mirror — Attach Mirror Hanging Hardware

Beginner3 hours

Part of project

How to Hang a Large Mirror on a Stair Landing · Step 5 of 7

Helpful?

In this video

Take one of the cut French cleat pieces and position it on the upper back of the mirror frame. Ensure that the 45-degree beveled edge faces away from the mirror. Use a cordless drill with a drill bit and a bit stop to drill pilot holes through the cleat and into the mirror's backing. The bit stop is crucial to prevent drilling too deep and damaging the mirror itself. Secure the cleat to the mirror using four 1 1/4 inch Torx wood screws, driving them through the pilot holes. Next, take the two 2-inch square plywood blocks and position one at each bottom corner on the back of the mirror frame. Drill pilot holes through these blocks and into the mirror's backing, again using the bit stop. Secure each block with 1 1/4 inch Torx wood screws. These bottom blocks will prevent the mirror from leaning forward once it is hung on the wall.

20.3K views146
Transcript
Hide

one half of the French cleat is going to be installed at the top of the mirror with the 45-degree angle away from the mirror the wall cleat will slide under the mirror cleat thank you to pilot holes are drilled on both sides of the French cleat with a bit stop so that the bit does not go too far into the mirror for one and a quarter inch torques wood screws were used to secure the cleat to the mirror the two square plywood blocks were used at the bottom of the mirror and pilot holes were drilled these blocks prevent the mirror from leaning down whenever it is installed on the wall the same one and a quarter inch torchwood screws were used we held the mirror up just to make sure

Auto-generated transcript. May contain errors.