Skip to main content

Mark & Cut New Treads/Risers — Cut New Treads

Intermediate4 mins

Part of project

How to Cover Waterfall-Style Stairs with Treads · Step 3 of 9

Helpful?

In this video

Carefully place the cardboard template onto the new red oak lumber (1x12 red oak is suggested, 3/4 inch thick and 11.5 inches wide, available at home centers). Ensure the template is positioned so that the cut marks will result in a tread of the correct length and the nosing (rounded edge) remains intact. Secure the template to prevent movement while tracing. Once transferred, use a small circular saw to make the initial cuts along the marked lines. Then, use a router with the appropriate bit to create the rabbet joint on the back edge of the tread. This rabbet cut will form the tongue that fits into the dado (groove) on the existing stringer, allowing the tread to sit flush and securely. For accuracy, make sure the template marks are visible, and cut just outside the line to allow for fine-tuning if necessary. Remember that the cuts are not always square or parallel, so precise marking is essential.

1.7M views15.3K