Identify and Disconnect Wires
Part of project
How to Install a Motion-Sensor Light Switch in a Stairway · Step 3 of 8
In this video
With the old switch pulled out, use a non-contact voltage tester to confirm that the wires are completely dead and there is no live current. The video demonstrates confirming the wires are dead. Identify the ground wire (typically bare copper or green), the power wire (often black, bringing electricity from the source), and the lead wire (often black or red, taking power to the lights). On the existing switch, the top terminal typically sends power, and the bottom terminal receives it, which helps identify the load and line wires if not explicitly colored. Loosen the terminal screws on the old switch using a screwdriver and carefully disconnect all wires: the ground wire, the power wire, and the lead wire to the lights.
Identify and Disconnect Wires
Part of project
How to Install a Motion-Sensor Light Switch in a Stairway · Step 3 of 8
In this video
With the old switch pulled out, use a non-contact voltage tester to confirm that the wires are completely dead and there is no live current. The video demonstrates confirming the wires are dead. Identify the ground wire (typically bare copper or green), the power wire (often black, bringing electricity from the source), and the lead wire (often black or red, taking power to the lights). On the existing switch, the top terminal typically sends power, and the bottom terminal receives it, which helps identify the load and line wires if not explicitly colored. Loosen the terminal screws on the old switch using a screwdriver and carefully disconnect all wires: the ground wire, the power wire, and the lead wire to the lights.