Skip to main content

Thread and Terminate Tensioning Cable Ends — Attach Tensioning Fitting to First Cable End

Beginner4 hours

Part of project

How to Tension and Adjust Stair Cable Railing · Step 2 of 8

Helpful?

In this video

Once one end of a cable is crimped, thread the cable through all the pre-drilled holes in the stainless steel posts. Ensure the cable passes smoothly through each post. Once threaded, take the tensioning swage fitting (a threaded end designed for tensioning) and insert the free end of the cable into it, pushing until it bottoms out. As with the previous step, use the crimping tool to make two crimps, rotating 90 degrees between each, for a secure connection. After crimping, slide a washer onto the threaded portion of the tensioning fitting, followed by a nut. Hand-tighten the nut to hold the cable in place, but do not apply full tension at this stage. Repeat this for all cables.

6.8K views1.0K
Transcript
Hide

then okay i'm going to show you the final step here is we're going to terminate these into the threaded end here so once you did this enough you'll get you get on to it uh what i what i found is if you just rest your cutter right along the edge and it's just a just a pair of snips and they come with the roll of cable usually and same thing we're going to make sure that we stick this all the way to the bottom of that same thing with the crimpers i don't know how good my angle is on the camera here but i apologize the same thing about a quarter inch in i like to do is just get a bite on it then when you follow through with it it pretty much keeps it in place we're going to do the same thing we're going to rotate this 90 degrees of the last crimp and it'll just gives it more more rigidity and then we're going to feed this through and just enough to get a washer and a nut on here and we don't want to tension this at this point all you want to do is just you're doing everything hand tight and there we go so we're going to get all the rest of these cables done and i'll show you the procedure for tensioning but we're not going to put full tension on until i'm done putting the cap rail on this and that'll probably be somewhere towards spring so i hope you enjoyed this i'll give you one more shot here when i get the rest of these terminated but uh you can see the the real clean look uh cable rail systems are they're they're still pretty popular um amazon sells all the stuff for it all

Auto-generated transcript. May contain errors.