Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 4 · Test for Leaks

Turn the water supply back on and carefully inspect all connections for leaks. If any leaks are detected, immediately turn off the water, tighten the connections, or reapply plumber's tape as needed. Retest until all leaks are resolved.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 4 · Test for Leaks

Turn the water supply back on and carefully inspect all connections for leaks. If any leaks are detected, immediately turn off the water, tighten the connections, or reapply plumber's tape as needed. Retest until all leaks are resolved.

Videos for this step

Turn Water On and Check for LeaksTurn Water On and Check for LeaksReconnect supply line

← Project

Shower Hardware Replacement: A Step-by-Step DIY Guide

Step 4 of 4·5 min left

Turn Off the Water Supply
5 minsBeginner
Remove the Old Shower Hardware
10 mins2 itemsIntermediate
Install New Shower Hardware
30 mins2 itemsIntermediate
4
Test for Leaks
5 minsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.