Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 4 · Install New Hardware and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Install the new shower handle(s), escutcheon plate, showerhead, and tub spout. Slowly turn the water supply back on, checking carefully for any leaks around the valve and connections. Adjust the temperature if needed. If leaks persist, carefully re-check all connections and tighten as necessary.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 4 · Install New Hardware and Test for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Install the new shower handle(s), escutcheon plate, showerhead, and tub spout. Slowly turn the water supply back on, checking carefully for any leaks around the valve and connections. Adjust the temperature if needed. If leaks persist, carefully re-check all connections and tighten as necessary.

Videos for this step

Reassemble and Test the FaucetTest the RepairTest for Leaks

← Project

Shower Faucet Replacement: A Complete DIY Guide

Step 4 of 4·30 min left

Shut Off the Water Supply
5 minsBeginner
Remove the Old Shower Hardware
15 mins1 itemsIntermediate
Install the New Shower Valve
1 min2 itemsAdvanced
4
Install New Hardware and Test for Leaks
30 minsIntermediate
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.