Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 6 · Restore Water and Check for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Before restoring power, you must refill the tank and check for leaks. First, make sure the drain valve at the bottom of the water heater is fully closed and the garden hose is removed. Go back to the sink where you opened the hot water tap and close it. Return to the water heater and slowly open the cold water supply valve by turning it counter-clockwise. You will hear water rushing into the tank. While it fills, keep your eyes on the new expansion tank connection. Once the tank is full (the rushing sound will stop), thoroughly dry the connection with a paper towel and watch closely for any sign of moisture or dripping. If a leak appears, turn off the water and tighten the connection another quarter-turn.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 6 · Restore Water and Check for Leaks

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Before restoring power, you must refill the tank and check for leaks. First, make sure the drain valve at the bottom of the water heater is fully closed and the garden hose is removed. Go back to the sink where you opened the hot water tap and close it. Return to the water heater and slowly open the cold water supply valve by turning it counter-clockwise. You will hear water rushing into the tank. While it fills, keep your eyes on the new expansion tank connection. Once the tank is full (the rushing sound will stop), thoroughly dry the connection with a paper towel and watch closely for any sign of moisture or dripping. If a leak appears, turn off the water and tighten the connection another quarter-turn.

Videos for this step

Refill the Water HeaterRefill Tank and Restore PowerFill and Test for Leaks

Tools and Materials

← Project

How to Replace a Water Heater Expansion Tank

Step 6 of 7·30 min left

Isolate the Water Heater
10 mins3 itemsBeginner
Relieve Pressure and Partially Drain Tank
15 mins2 itemsIntermediate
Remove the Old Expansion Tank
15 mins4 itemsAdvanced
Check and Adjust New Tank Pressure
10 mins2 itemsIntermediate
Install the New Expansion Tank
10 mins3 itemsIntermediate
6
Restore Water and Check for Leaks
15 mins2 itemsIntermediate
7
Reactivate System and Purge Air
15 mins2 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.