Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 5 · Install the New Expansion Tank

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Prepare the threads on the new expansion tank for a watertight seal. Take the roll of Teflon tape and, holding the tank with the threads facing you, wrap the tape clockwise around the threads. Use 3 to 4 full wraps, pulling the tape taut so it sinks into the grooves of the threads. Wrapping clockwise ensures the tape won't unwrap as you screw the tank in. Carefully lift the new tank and align its threads with the female fitting on the water pipe. Screw it in by hand for the first few turns to prevent cross-threading. Once it's hand-tight, use the pipe wrench to tighten it an additional 1 to 1.5 turns. The tank should feel snug and secure; do not overtighten.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Install the New Expansion Tank

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

Prepare the threads on the new expansion tank for a watertight seal. Take the roll of Teflon tape and, holding the tank with the threads facing you, wrap the tape clockwise around the threads. Use 3 to 4 full wraps, pulling the tape taut so it sinks into the grooves of the threads. Wrapping clockwise ensures the tape won't unwrap as you screw the tank in. Carefully lift the new tank and align its threads with the female fitting on the water pipe. Screw it in by hand for the first few turns to prevent cross-threading. Once it's hand-tight, use the pipe wrench to tighten it an additional 1 to 1.5 turns. The tank should feel snug and secure; do not overtighten.

Videos for this step

Install New TankPrepare the New Expansion TankInstall New T&P Valve

Tools and Materials

← Project

How to Replace a Water Heater Expansion Tank

Step 5 of 7·40 min left

Isolate the Water Heater
10 mins3 itemsBeginner
Relieve Pressure and Partially Drain Tank
15 mins2 itemsIntermediate
Remove the Old Expansion Tank
15 mins4 itemsAdvanced
Check and Adjust New Tank Pressure
10 mins2 itemsIntermediate
5
Install the New Expansion Tank
10 mins3 itemsIntermediate
6
Restore Water and Check for Leaks
15 mins2 itemsIntermediate
7
Reactivate System and Purge Air
15 mins2 itemsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.