Skip to main content
RR BuildingsRR Buildings
BrowseMy Projects
Log inSign up
RR Buildings

Step 4 · Deburr and Clean Pipe Ends

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

After cutting, the pipe ends will have sharp edges and small burrs. These must be removed to prevent them from slicing the O-ring inside the push-to-connect fitting, which would cause a leak. Use a deburring tool to ream the inside edge and smooth the outside edge of both cut ends of the copper pipe. Once smooth, use a clean cloth to thoroughly wipe the ends of the pipes, removing any copper filings, dust, or oils.

Stesso home
SearchSearchBrowseBrowseMy ProjectsMy Projects
Log inLog inSign upSign up

Step 4 · Deburr and Clean Pipe Ends

This is the step people usually slow down on. Go finger-tight first, then a quarter turn. No rush — replay the clip whenever it helps.

After cutting, the pipe ends will have sharp edges and small burrs. These must be removed to prevent them from slicing the O-ring inside the push-to-connect fitting, which would cause a leak. Use a deburring tool to ream the inside edge and smooth the outside edge of both cut ends of the copper pipe. Once smooth, use a clean cloth to thoroughly wipe the ends of the pipes, removing any copper filings, dust, or oils.

Videos for this step

Prepare Copper PipesDeburr the Cut EndDeburr the Copper Pipe

Tools and Materials

← Project

How to Install a Water Hammer Arrestor to Stop Banging Pipes

Step 4 of 7·45 min left

Diagnose and Locate the Problem
15 minsBeginner
Shut Off Water and Drain the Pipes
20 mins2 itemsIntermediate
Cut the Pipe
10 mins6 itemsAdvanced
4
Deburr and Clean Pipe Ends
5 mins2 itemsIntermediate
5
Install the Fitting and Arrestor
15 mins4 itemsAdvanced
6
Restore Water and Check for Leaks
15 mins1 itemsIntermediate
7
Test the System
10 minsBeginner
Prev
Next
TermsPrivacySafetyLegal© 2026 Stesso, Inc.